There is a reason for USB-C extensions not to be part of the standard. They can be bothersome in the best case and dangerous in the worst.
There is a reason for USB-C extensions not to be part of the standard. They can be bothersome in the best case and dangerous in the worst.
So a standard cable needs to be chipped to show its rating to the device, its not that the device can pull what it wants or can get, but the cable itself tells it what it can supply. Extension cables can’t do that, because it doesn’t know what it’s plugged into, and that would be if they even bothered to put a chip in. They instead piggy back off the chip for the main cable. The problem comes when you you have a 240 watt cable hooked up to a cheap 120 watt cable, with the device being told it can push 240, and starts to super heat the extension cable
Brilliant thanks
5 sentences that inexplicably need a 9 minute video to say
Fuck YouTube
deleted by creator
Correct, except for your example. Firstly, 120 watt USB c cables don’t exist, only 60w, 100w, 140w and 240w. And only plugging in a 100w or higher cable into a 60w extension would be dangerous, since it would allow drawing 5 amps on a cable over an extension only designed for 3 amps. However, as soon as your extension is rated for 100w it is completely safe to use with any USB c cable, even those rated for 240w, as those only operate at a higher voltage but still only allow 5 amps max.
I have also never seen an USB C extension cable rated for less than 100w, so this is kind of a moot point. If 60w usb c extensions exist somewhere, they would indeed be dangerous, but I have never come across one
Soon on Amazon…
1m USB-C CABLE HEATER!! 0.99c
($5.99 shipping)
This sounds solvable, doesn’t it? Have the extension cable have a chip saying it can do X at maximum, then compare with whatever is to be extended and communicate the minimum of both upstream. Might not become a sleek cable-like design, but would extend the 240W cable with the extender safely staying at 120W
That’s an active extension cable, which is essentially a single port USB hub.
Shouldn’t it be possible to only do the negotiation part and otherwise bridge everything? Not having to do anything high-bandwidth actively should keep the silicon costs down.
Yes, and such cables already exist, like this splitter cable:
https://www.amazon.de/dp/B0CRZ6JJ6D (not an affiliate link)
It’s not an extension cable, but it does exactly what you are suggesting. It gets the available PD profiles from the charger and then intelligently negotiates a profile that will work best to split the power to the 2 devices connected to it. The charger thinks it’s just connected to 1 device, and the connected devices think they are directly connected to a charger.
Doing the same for with a USB C extension would be trivial, but it’s probably hard to market such a cable when passive USB c extension cables are available at a fraction of the cost, even if those aren’t compliant to the USB standard
I wish there was a clearer explanation or nomenclature for this. With things like cables and converters everything always seems to have a black box layer.
I don’t understand why there are so many PD profiles either. Maybe Cat-1 USB-C, Cat-2 USB-C, etc? Maybe just having a smaller set of voltage-defined profiles that have a safe maximum current rating? Maybe that’s already how it is? I don’t know
There are technical reasons for why so many PD profiles exist.
In fact they were not enough, which is why the USB Standard was extended with the “PPS” extension recently, which let’s the attached device freely choose a voltage between 3V and 21V in steps of 20mv, and more importantly it let’s the device freely change this voltage without interrupting the charge process. This change makes it possible for devices to bypass their own but in charging electronics and just directly forward the voltage coming from the charger to the device, improving efficiency and significantly decreasing how much the device hears up during charging
Sadly PPS is not found on many devices or chargers yet, and makes the already complicated USB C charging situation even more complicated for consumers
I am highly sceptical of anything that would connect USB voltage, no matter how finely negotiated, directly to the battery terminals. Finely tunable voltage over USB is useful for keeping the buck/boost converter on the device side small, though, or just efficient because it doesn’t have to do as much work. If you can charge over standard PD extending to charging over PPS should only be a software change as your hardware is already more than capable.
Heh heh heh. Wait till you dive into the world of “That $15 cable costs 12c to make.”
I’m right now in China and those cables cost $0.50 shipped to your address, so not surprised
Getting $30 cables for $3 with my employee discount was almost the only good thing about working for Best Buy in the early 2000s.
Well, the source checks the cable using the CC line which doesn’t go through the cable (VCONN). So source only knows the cable directly plugged in. To make the extension cable visible, the sink would be required to check the cable plugged in using VCONN and then the tell max ampere to the source over the other CC that goes through the cable.
2 Problems:
Sink devices normally don’t read or can’t read VCONN as far as I know
No way of detecting if a third cable (extension in the middle) is present and what specs it has
Well I’m glad I know that now.
Pretty much this, thanks for the summary
How did we possibly survive with entirely dumb power chords?
Safety regulations are written in blood. Electrical fires were indeed a problem. It’s why there are rules on how many outlets need to be in a room, how spaced out they need to be (to curtail extension cord usage even when the builders are trying to be cheap and stingy with outlets). It’s the reason why we have breakers and GCFIs and RCBs and AFCIs. It’s the reason why we have electrical certification bodies like UL which won’t certify your cable or appliance if the cords are too thin.
There’s a lot of smart stuff we do behind the scenes to make dumb cords safe because even smart people make dumb mistakes.
“Dumb” power cords have thicker gauge wire than USB-C cables and much larger contacts.
This is not about contacts but cableburning tho.
Hence the thicker gauge wire.
Interesting, I’d never trust any USB cable to push anywhere near 100 watts anyway haha good god, the most I ever do is maybe 20w at 5v.
I’ll keep that in mind when buying cables in the future though this is very useful info!
As a point of reference, Lenovo Thinkpad’s have something of a cult following for their reliability and versatility.
My T490s has a USB-C power supply which provides 45w (20v at 2.25a).
The thing is, when docked it’s not only pulling power through that cable, but also network, USB devices, and providing video for 2x monitors in 1920x1080. It’s kind of astonishing to me how much can be crammed in to one little connector. That said, it’s frustrating trying to find a usb cable that works reliably, because as you’d imagine not all USB-C cables support the same specs.
Is the dock USB-C or Thunderbolt?
It’s USB-C.
If you buy a Steam Deck, or the Lenovo laptop I have for work, the only charging options you have are USB C. Their standard chargers put out at least
6045 W, and they aren’t particularly special. In fact, I’m pretty sure 20 W at 5 V won’t be enough to supply these while in use, so you will either be using battery with long charge times in between, using them with battery-assisted power for longer use times until you hit those long charge times, or using the6045 W or more at whatever voltage the chargers provide.The Steam Deck charger is 45W.
While this is handy to know, it doesn’t negate my point.
IIRC the one that came with my OLED model is 65WIt appears I did not remember correctly
I’m looking at the one for my OLED deck right now and it’s labelled as 45W (20V 2.25A).
The ones I’ve seen that go over 45W specifically for the Steam Deck are mini docks with HDMI out and more
My laptop can do 240W over USB-C, I’m just waiting for a charger that can do it with a modular cable
It has a 240w charger but have you checked to see that it’s using all 240w?
Most laptops use (up to) 120w.
It can use almost all of it using the GPU
What’s the make and model of the laptop?
Framework 16